### OBSDATE ### 20130429 ### LOGDATE ### 130429 ### OBSERVERS ### MJI ### WEATHER ### Clear, 70% humidity (start) to 80% (end), no wind on SUSI envirogtk, , 20C ATCA: 60% humidity, also no measurable wind (2 km/hr at the very start) ### LOCATION ### Home ### PROGRAM ### Aaron's Sco-Cen binary program. Missing cal for hr 5395 so not observed. Also second (later) hour angle needed for all targets (Aaron's groups 1,2,3,4) but I have a 9am meeting... [NB this program was just about scriptable by the end. Occasional fake locks on search and PAVO gain set wrong were the only issues] ### SIDEROSTATS ### n4 s3 ### TARGETS ### hr 4656 hr 4798 hr 4199 hr 4798 (low V^2 - is this right? surely not the secondary?) hr 4656 *** hr 4897 hr 4940 hr 4942 hr 4940 *** hr 5695 hr 5812 hr 5948 hr 5812 hr 6252 hr 6165 hr 5948 hr 6165 hr 6252 hr 6165 *** hr 5948 hr 5712 hr 5839 (no fringes found) hr 5987 (fringes at -280) *** hr 5987 (fringes at -180, dispersion off, airoffset 1 after a brief "tg". Also tried to align tip/tilt but it was pretty good to start with) hr 5839 (clear fringes at -180 this time, V^2 peaking at 0.2-ish) hr 5948 (V^2 peaking at 0.6-ish) hr 5948 ### QUALITY ### Very good (several calibrated points) ### PROBLEMS ### Aaron had left the apertures in somehow. Maybe they are automatically put "out" and if the lab switches are in "reverse" then they go in? Fixed easily by bringing the "apgtk" gui up. Visibility looked reasonably good, fringes at -300, 1.8:1 ratio N:S. Decided not to align as it had been done recently. Also left the LDC wavelength at 500nm and didn't do "tg" in the beginning as dispersion was near 0. On shutdown, shutting down PAVO made the sidcons crash, and shutting down the sidcons made error messages in PAVO. Acqlabjack park gives an error in taskmaster if it is already parked and off. Zeroset found at 2 microns.